additional tax points for invoicing, contact customer service for details!

(1) hold the connecting base in one hand and press the retaining ring in the other hand to pull down to separate the connecting base from the water inlet pipe.

(2) loosen the four fastening screws on the upper connector and screw down the connector to make the upper and lower connectors have a gap of 3 threads. If the faucet is too thick, you can remove the plastic guide sleeve inside.

(3) adjust the 4 screws of the connector evenly to make the 2 screws on the wall fully contact with the outside of the faucet. Screws near the wall can be screwed into some by hand in advance.

(4) put the upper connector against the faucet, making its internal sealing ring fully contact with the faucet. Note: do not take out the sealing ring, and the faucet mouth is flat.

(5) rotate the two screws on the opposite side of the wall to make it contact with the faucet, and then tighten it with a screwdriver.

(6) rotate the lower connector until the upper and lower connector is tightened. The gap between the two is 3mm.

(7) press down the retaining ring of gold market management.

(8) insert the inlet pipe upward into the lower connection base, and then loosen the retaining ring.

(9) check whether there is water leakage. If there is water leakage, reinstall it. Note that the faucet should use standard faucet