additional tax points for invoicing, contact customer service for details!

Faucet leakage water treatment method
in normal life, sometimes I find that the water of the faucet still drips after tightening, and drips continuously from the outlet of the faucet or the joint, which not only causes a lot of waste, sometimes its noise will also cause some troubles. In fact, the structure of the faucet is very simple. You can repair the leakage by yourself. Generally speaking, the leakage problem only needs to be replaced with a seal types of parts such as the axis gasket or triangle a seal inside the faucet, it can be solved. However, you have to turn off the main tap switch at home before renovation.

As for the repair of water leakage at the faucet joint, the cause of water leakage is nothing more than the sealing tape damage of the faucet part (fixing screws). Therefore, just use the plate pliers to remove the faucet and re-roll the new sealing tape at the place where the screw is fixed. The following are the maintenance steps: first, tie the faucet tightly, turn the faucet counterclockwise with a plate clamp. Second, put the tapping hole outward and roll it 5-6 times with wind-printed tape clockwise on the thread part.

Check whether the faucet has been adjusted. The water clamp is tied in clockwise directions. After the installation is completed, turn on the main switch and try to check whether there will be water leakage.

Even if the faucet is tightly tied, the reason why it still leaks is:

1. The reason for the water outlet leakage: it is caused by the wear of the Axis gasket in the faucet. Use pliers to loosen the gland and remove it. Take out the axis gasket with a clip and replace it with a new axis gasket.

2. The reason for the leakage of the gap in the lower part of the faucet tie: it is caused by the abrasion of the triangle a seal in the gland. You can loosen the screw and remove the bolt head, then loosen the gland and remove it, then take out the triangle seal shop inside the gland and replace it with a new one.

3. Leakage at the joint of the connecting pipe: Generally speaking, the cap nut is loose. At this time, you can re-tighten the cap nut or replace it with a new U-shaped a seal.