1, summer temperature regulation
refrigerator (freezer) in the use of the process, its work time and power consumption is affected by environmental temperature influence is very big, so need to us in different seasons to choose different file to use.
ambient temperature is high in summer, should hit the weak 2-3 files using the file.
: in summer, the high temperature environment, and at the same time, the temperature in the box every drop 1 degree are very difficult, through casing heat insulation layer and a door seal cold loss will accelerate, it will appear a very long boot time and down time is very short. This will lead to the high temperature of the compressor running at high temperature, the piston and the cylinder, the insulation performance of the motor coil wire insulation will also be reduced by high temperature, power consumption will also rise sharply, that is not economic and unreasonable. If at this time to play weak file (2.3), will find the starting time is significantly shorter, the time to stop, so that saves power, and reduce the compressor wear, prolong service life. So in the summer when the temperature control to the temperature control device to the weak file.

3 , ambient temperature in winter can not be too low
because you use the refrigerator is a single system refrigerator, that is to say, the freezing temperature is refrigeration controller through the regulation and system matching to complete, if the ambient temperature is too low, the refrigeration temperature starting a few minutes may shut down, resulting in the freezer temperature up to. Sometimes the environment temperature is lower than the temperature of the refrigeration, the refrigerator will not start. Therefore, the general situation of the refrigerator should not be placed below the 5 level of the environment.

4 boot time long
this mainly due to the environment due to high temperature. Due to high ambient temperature in summer, the refrigerator cooling is slow, and the time of the refrigerator is relatively long. Any refrigerator has a temperature range, with the increase of ambient temperature, the running time will be extended, user guide:
instructions please pay attention to the following points: in use

1) refrigerator to open the door to minimize the number and the time to open the door.
2) after closing the refrigerator door must check whether the door locked, the door seal seams to prevent leakage.
3) refrigerating chamber for placing food to has left some gaps, especially the food not to close to the rear wall of the refrigerated container.
4) freezer try not to place a large moisture food, if you really want to place, the best preservative film seal.
5 attention drain is blocked by dirt, if blocked, with through hole pin or other similar plastic stick to clear.

6, check drainage pipe. If the drain plug, the water will leak into the refrigerator. To stab a drain pipe with a wire, remove the product from the drain.

7 , often clean the back of the refrigerator or the bottom of the condenser and the dust on the compressor. Can use the vacuum cleaner or brush dust. Pay attention not to clean dust on the compressor and refrigerator with a damp cloth.
8, don't ignore door sealing adhesive tape cleaning and bleaching agent with 10 times of the water dilution with a toothbrush dipped in wet cleaning, the last water bleaching agent rushed. Rubber dirt easily aging, will affect the sealing performance of the refrigerator, increase power consumption.

9 , the long-term use of the refrigerator, should cut off the power, remove all the food inside and outside the box, clean the box, open the door for a few days, so that the box is fully dry and loose the smell of the refrigerator.

10 , pay attention to check whether there are cracks in the power line, to prevent leakage.