Home foil method:
Tools / raw materials
& Nbsp; Scraper: one (Gift)
& Nbsp; & nbsp; knife: a (gift)
& Nbsp; & nbsp; Drum: A (self)
& Nbsp; & nbsp; Water: Amount & nbsp; (if direct use of tap water,To go through precipitation,Because there are many impurities in the water pipe, or sand)

Method / step
& Nbsp; The first step: first filled with water inside the pot, you can add a few drops of detergent is also appropriate, water can also
& Nbsp; Step 2: Put the first car glass above the water
The third step: spray water is to cut the size of the first film to cut (the glass spray on the water film easy to stick, easy to cut)
Step 4, the film attached to the water sprayed on the glass above the edge of the edge of the edge of about 0.5 cm to stay on the line, before and after the first point of the line, and then cut down
Step 5: Cut the size of a piece, and then cut the specific good, you can shake the glass a little bit down, cut the knife along the edge of the glass cut, and then put the film first to a ; & Nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp;Membrane is divided into positive film, You first hand deduction point, the front of the viscose is the glass of the car, I made this mistake, cut & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; anti, so everyone Remember)
Step 6: the door open, the inside of the water with the jug and scraper repeated ten times must be clean, or easy to carry something inside, and it is easy to blister
Step 7: clean up the glass, then spray the water will not control, and then just ready to open the membrane, then remember to spray the film on the film, or else it is above There is glue on the sticky, and then aligned on the glass paste up, and then the edge of the location of the card can be sealed inside, and () To just peel off the plastic film do not throw away & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; & nbsp; yo, useful)
Step 8: paste almost, with a watering cans in the paste on the film above the water spray, just peeled off the plastic and then paste it, with the scraper to make it point to scratch it, (the plastic film Put on the film is not bad, or else are spent, I did not paste the beginning of this layer directly scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping scraping Spent, distressed)